Designation: D − 10Standard Test Method for Energy Measurement for This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Purchase your copy of ASTM D – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. ASTM D ,. “Standard. Test Method for Stress Wave. Energy Measurement for Dynamic. Penetrometer. Testing. Systems”. , speclfles.
|Published (Last):||2 March 2014|
|PDF File Size:||9.72 Mb|
|ePub File Size:||8.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
This energy measurement procedure can evaluate variations of N-value resulting from differences in the hammer system.
Aatm more about SIS Subscriptions. Since the measured energy includes the extra potential energy effect due to the set per blow, tests for energy evaluation of the hammer systems should be limited to moderate N-value ranges between 10 and 50 Ref 7.
Valid Buy this standard. The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Soil and Rock I: In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs.
It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design. What is a standard? When you use our service you can be assured the latest editions and easy access.
Standard Test Method for Energy Measurement for Dynamic Penetrometers
Report error on page. The inch-pound units given in parentheses are r4633 conversions which are provided for information purposes only and are not considered standard. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, d46633 any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations.
Users of this standard are cautioned that compliance with Practice D does not in itself assure reliable results.
Link to Active This link will always route to the current Active version of the standard. Historical Version s – view previous versions of standard.
ASTM D4633 – 16
Contact us svenska Login. These notes and footnotes excluding those in tables and dd4633 shall not be considered as requirements of the standard. Subscribe on standards – Read more. It is the responsibility of the user of this standard aztm establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The standard is now in your shopping cart.
Please note that the selected standard is invalid. In addition, they are representative of the significant digits that generally should be retained.
See also Refs 1- 6. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method. Referenced Documents purchase separately D46333 documents listed below are referenced within the subject standard but are not provided as part of the standard. It is not intended for use with down-hole hammers.
This procedure may also be applicable to other dynamic penetrometer tests. Reliable results depend on many factors: Your shopping cart is empty. Subscribe on standards with our subscription service. Shopping cart Close cart 0, foreach: Sustainable Development Goals and standardisation, how do they connect? In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs.
This procedure may also be applicable to other dynamic penetrometer tests. The N-value depends on the soil properties but also on the mass, geometry, stroke, anvil, and operating efficiency of the hammer. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.
ASTM D – 16 – Standard Test Method for Energy Measurement for Dynamic Penetrometers
Message to your colleague.
ASTM D – 05 Standard Test Method for Energy Measurement for Dynamic Penetrometers
Practice D provides a means of evaluating some of those factors. Alternatively, the N-value can be used directly in foundation design using correlations to design parameters such as allowable bearing pressure or pile capacity. The Standard Penetration Test is the most common type. It is not intended for use with down-hole hammers.